Original EFR ES80 Power Supply / Power Source with PFC Function 90V-250V

Description

Description
Original EFR ES80 Power Supply / Power Source with PFC Function, for EFR F2, ZS1250 CO2 Sealed Laser Tubes, 90V-250V
Please contact us freely if you have any interest
Description:
EFR power supplies for CO2 laser tubes adopt zero-current half-bridge soft-switch circuit to ensure the equipment has advantages of high efficiency, rapid response speed and simple port control, and applicable to two signals – high and low level. TTL level is to control the laser on/off, in the meantime, the power supply has an anomalistical protective switch to check whether the outer water and air, etc.
Features:
1.Initiative PFC function, AC90-250V wide input voltage range, universal for all countries voltage.
2.Special design for outer shell, more beautiful appearance, better heat dissipation.
3.Improved current control mode, more stable laser, better compatibility, more adaptable for different kinds of laser tubes.
4.Simple power control, user can control laser with high or low level signal.
5.With test button, easy to test laser tube and power supply.
6.Small size outer shell, suitable for installing on the beam of cutting bed.
Item
CS-PS-ES80
Input
Input Voltage
AC90-250V
AC Frequency
47 - 440Hz
Max Input Power
500W
Max Input current(when 90V input)
6A
Output
Max output Voltage
40KV
Max Output current
28mA
Efficiency
90%(full load) min
MTBF(mean time between failure)
10000hours min
Response speed
≤1mS(the time from the signal is given to output current reaches 90% of set current )
Withstand voltage
Input-output, input-shell:AC1500V 10mA 60s
Working environment
Temperature(-10~40) , relative humidity:≤90%
Cooling
Force air cooling
Network cable
Length(M)
1.5M/3M
Dimension
LxWxH(MM)
235
x
144
x
104
Packing size
LxWxH(MM)
250x150x140
Weight
Net weight(KG)
2.15
Gross weight(KG)
3
Color
Silver grey
P1 High voltage indicator light
P2 FG: ground connection; AC: input
P3 Test button
P4 terminal definition
TH
Input signal
Laser on/off control, laser on when high level(≥3V), laser off when low level(≤0.3V)
TL
Input signal
Laser on/off control, laser off when high level(≥3V), laser on when low level(≤0.3V)
WP
Input signal
Laser on/off control, laser off when high level(≥3V), laser on when low level(≤0.3V)
G
Signal ground
This terminal must be connected with outer shell and control board of machine properly
IN
Power signal
Laser power control terminal, control with 0-5V analog signal or 5V PWM signal
5V
Output
5V output, max output current is 20mA
Advantages:
Application:
Es-80 Laser Power Supply is used for 60W,80W Cutting and Engraving Acrylic, Fabric, Double Color Sheet and Rubber,ect.
Package: