VEVOR Laser Power Supply 80W Co2 Laser Engraver Power Supply 110V Laser Tube ...

Description

VEVOR Laser Power Supply 80W Co2 Laser Engraver Power Supply 110V Laser Tube Power Supply for Laser Cutter Engraving Machine(80W)
【HIGH EFFICIENCY】- This power supply uses a zero-current half-bridge soft switching circuit, which makes the power supply highly efficient and fast in response.
【SIMPLE PORT CONTROL】- Suitable for high and low-level signals. Use the TTL level to control the laser start and stop. At the same time, a protection switch is added to detect whether there is water or ventilation outside.
【LASER POWER ADJUSTMENT】- The laser power adjustment can input 0 to 5V analog signals, can also input PWM signals.
【OPEN CIRCUIT PROTECTION】- The power supply has an open circuit protection function, which can avoid damage to the laser power supply due to the burst of the laser tube.
【FACTORY AGING TEST】- Each power supply will be subjected to a high temperature 60 ° C 12-hour aging test under full load, and the power supply test will be started and stopped 500 times in 7 seconds.
Laser Power Supply
The CO2 laser power supply is small in size, light in weight, easy to operate, and has good matching performance with the laser tube, which can be directly connected to the laser tube. Fast response speed, good effect, high performance, high cutting power, and can extend the life of the laser tube.
High Performance
Fast response speed, good effect, high performance, high cutting power, and it can extend the life of the laser tube.
Easy Control
Laser power supply machine start and stop can be easily controlled by TTL level.
Simple Laser Power Control
Two methods to adjust laser power: Input 0V to 5V analog sighnal, can also input PWN signal.
Mark Clearly
Each data is clearly marked for your convenience.
Power detection instructions: When the power supply is in standby state, press the test switch. if the L light is on and the P light is on, laser tube does not output laser, the laser tube is broken. If the laser tube outputs laser, the laser power is normal; if the LASER lamp is off, the laser power is bad.
Protection Function
Open circuit protection function, it can be used to detect the presence or absence of waterway, protect the laser; It can better protect the laser power and prolong the service life.
Good Compatibility
Co2 laser engraver power supply is suitable for a variety of CO2 laser tubes.
Specification:
Input voltage: AC110V / AC220V
Maximum output voltage: 26KV
Maximum output current: 28mA
Efficiency: 91%
Response speed: ≤1ms
Cooling method: fan cooling
Gross Weight:2.3kg/5.11lbs
Package Size: 27x20x14cm/10.62x7.87x5.51inch
Package Content:
1 x high voltage connector
1 x laser power supply
Shipping
We offer FREE shipping on all orders!
We ship within Three business days of payment, usually sooner.
We use a selection of shipping services such as UPS, FedEx, USPS etc.
We only ship to the lower 48 states, no APO/FPO addresses or PO Boxes allowed.
Local pickups and combined shipping options are not provided at this time.
Return
You can return a product for up to 30 days from the date you purchased it.
Any product you return must be in the same condition you received it and in the original packaging. Please keep the receipt.
Payment
We accept payment by any of the following methods:
PayPal
Please pay as soon as possible, as that will allow us to post your item to you sooner!
Feedback
Customer satisfaction is very important to us.
If you have any problem with your order, please contact us and we will do our best to make you satisfied.
Contact Us
If you have any queries, please contact us via ebay. We usually respond within 24 hours on weekdays.
Please visit our eBay store to check out other items for sale!
Thank you for shopping at our store.